Browse wiki

From Open Energy Information

DOI-BLM-NV-C010-2011-0527-CX
Applicant AltaRock Energy Inc +
CXReference DOI.516.DM.11.B.6 +
CompletionNotes No document available to further populate.  +
EnergyTechnology Geothermal energy  +
EnvironmentalAnalysisType CX +
ExplorationTechnique Passive Seismic Techniques +
GeothermalArea Dixie Valley Geothermal Area +
GeothermalDevelopmentPhases Geothermal/Exploration +
LeadAgency Bureau of Land Management +
ManagingDistrictOffice BLM Carson City District Office +
ManagingFieldOffice BLM Stillwater Field Office +
MineralManager Bureau of Land Management +
NEPA-Name CX for Passive Seismic Survey at Dixie Valley Geothermal Area for Geothermal/Exploration  +
NEPA Completion Notes No document available to further populate.  +
NEPA DecisionDocumentDate June 6, 2011  +
NEPA LeadAgencyDocNumber DOI-BLM-NV-C010-2011-0527-CX  +
NEPA Proposed Action This is a revision to AltaRock Inc.'s prev
This is a revision to AltaRock Inc.'s previously approved seismic survey reflecting revised locations. The new proposal also differs in the manner of installation. Original site locations and installation were analyzed under DOI-BLM-NV-COI0-2011-0008-CX. The new proposal is to conduct a passive seismic survey which will consist of 27 broadband seismometers installed over a broad area centered on Dixie Valley. Only 19 of these sites are located within the Stillwater Field Office, CCDO. The remaining 8 sites are located within the Winnemucca Field Office. The passive seismic survey is expected to last three months. Sites have been moved from the original proposal to be closer or adjacent to existing roads to mitigate overland travel. Ground disturbance would be limited to holes for placement of the seismometers. For each site a hole no more than 36 inches in diameter and 42 inches deep will be dug by hand or small Bobcat excavator with a bucket no larger than 12 inches wide, the smallest available. A container used to house the seismometer will be placed in the hole and cemented in place. The container will be covered with a removable tile and the entire unit backfilled to the surface. A cable will extend from the seismometer to the surface where it will be connected to a weatherproof box containing electronics, data logger, and battery. Solar panels used to recharge the battery would be mounted on top of the weatherproof box. The entire assembly would be mounted on two parallel horizontal pipes measuring approximately 7 feet long and 3 inches in diameter. Access would be through existing roads or short stretches of overland travel. Following removal of the seismometers the remaining vaults would be buried in place beneath at least 12 inches of soil.
place beneath at least 12 inches of soil.  +
NEPA SerialNumber NVN-089282  +
Name DOI-BLM-NV-C010-2011-0527-CX  +
OpenEI/PageDescription : NEPA document related to geothermal resource areas   +
OpenEI/PageKeyword Geothermal  + , Dixie Valley Geothermal Area  +
Place Nevada: Energy Resources +
ProposedAction This is a revision to AltaRock Inc.'s prev
This is a revision to AltaRock Inc.'s previously approved seismic survey reflecting revised locations. The new proposal also differs in the manner of installation. Original site locations and installation were analyzed under DOI-BLM-NV-COI0-2011-0008-CX. The new proposal is to conduct a passive seismic survey which will consist of 27 broadband seismometers installed over a broad area centered on Dixie Valley. Only 19 of these sites are located within the Stillwater Field Office, CCDO. The remaining 8 sites are located within the Winnemucca Field Office. The passive seismic survey is expected to last three months. Sites have been moved from the original proposal to be closer or adjacent to existing roads to mitigate overland travel. Ground disturbance would be limited to holes for placement of the seismometers. For each site a hole no more than 36 inches in diameter and 42 inches deep will be dug by hand or small Bobcat excavator with a bucket no larger than 12 inches wide, the smallest available. A container used to house the seismometer will be placed in the hole and cemented in place. The container will be covered with a removable tile and the entire unit backfilled to the surface. A cable will extend from the seismometer to the surface where it will be connected to a weatherproof box containing electronics, data logger, and battery. Solar panels used to recharge the battery would be mounted on top of the weatherproof box. The entire assembly would be mounted on two parallel horizontal pipes measuring approximately 7 feet long and 3 inches in diameter. Access would be through existing roads or short stretches of overland travel. Following removal of the seismometers the remaining vaults would be buried in place beneath at least 12 inches of soil.
place beneath at least 12 inches of soil.  +
SurfaceManager Bureau of Land Management +
Has query
"Has query" is a predefined property that represents meta information (in form of a subobject) about individual queries and is provided by Semantic MediaWiki.
DOI-BLM-NV-C010-2011-0527-CX + , DOI-BLM-NV-C010-2011-0527-CX + , DOI-BLM-NV-C010-2011-0527-CX + , DOI-BLM-NV-C010-2011-0527-CX + , DOI-BLM-NV-C010-2011-0527-CX + , DOI-BLM-NV-C010-2011-0527-CX + , DOI-BLM-NV-C010-2011-0527-CX +
Has processing error
"Has processing error" is a predefined property provided by Semantic MediaWiki and represents errors that appeared in connection with improper value annotations or input processing.
DOI-BLM-NV-C010-2011-0527-CX +
Categories NEPA Doc , Geothermal energy
Modification date
"Modification date" is a predefined property that corresponds to the date of the last modification of a subject and is provided by Semantic MediaWiki.
20:18:36, 18 June 2014  +
hide properties that link here 
  No properties link to this page.
 
Enter the name of the page to start browsing from.