A2e - UAE6 - UAE6 - Sequence Q - Raw Data

A2e

Atmosphere to Electrons (A2e) is a new, multi-year, multi-stakeholder U.S. Department of Energy (DOE) research and development initiative tasked with improving wind plant performance and mitigating risk and uncertainty to achieve substantial reduction in the cost of wind energy production.

The A2e strategic vision will enable a new generation of wind plant technology, in which smart wind plants are designed to achieve optimized performance stemming from more complete knowledge of the inflow wind resource and complex flow through the wind plant.

Read more ...

Project: Unsteady Aerodynamics Experiment Phase VI NREL-NASA Ames Wind Tunnel Experiment

The Unsteady Aerodynamics Experiment (UAE) was undertaken to acquire research-grade wind turbine aerodynamics measurements capable of expanding physical comprehension, improving predictive models, and advancing turbine technology and performance. Initiated in 1987 at the National Renewable Energy Laboratory’s (NREL) National Wind Technology Center (NWTC), the UAE evolved through five phases of field experiments during 1987 through 1998.[1-3] Concurrently, analogous wind turbine field experiments aimed at the same objectives were pursued at several laboratories in Europe and Asia.[4,5] Together, these field experiments succeeded in developing procedures and instrumentation for acquiring research-grade measurements in the field test environment and generally confirmed that turbine blades produced flow fields that were highly three-dimensional, strongly separated, and predominantly unsteady.

However, crucial details of the turbine blade flow fields remained obscure, overwhelmed by the temporal and spatial disparities imposed by turbulent atmospheric inflows. To isolate the key blade and rotor fluid mechanics details, atmospheric inflow anomalies needed to be eliminated. Thus, plans were launched simultaneously in the United States and Europe to carry out research-grade turbine aerodynamics experiments in the largest U.S. and EU wind tunnels. Documented and archived in the DAP UAE6 database, the NREL UAE Phase VI experiment was conducted in the National Aeronautics and Space Administration (NASA) 80 ft x 120 ft wind tunnel at the NASA Ames Research Center at Moffett Field, California.[6] The EU Model rotor EXperiment In COntrolled conditions (MEXICO) experiment was carried out in the German-Dutch Wind Tunnels (DNW) Large Low Speed Facility (LLF), located near Marknesse in The Netherlands.[7]

The DAP UAE6 database contains the measurements acquired via experiments in the NASA Ames 80 ft x 120 ft during 2000. The UAE Phase VI wind tunnel experiment objectives were to: 1) acquire research grade aerodynamic and structural measurements 2) on a subscale wind turbine geometrically/dynamically similar to full scale, 3) operating in a controlled, low-turbulence inflow environment.

Read more ...

Dataset Overview

Sequence Q: Dynamic Inflow (P)

This sequence was designed to characterize the dynamic inflow variation using the five-hole probes that extend upwind of the leading edge of the blade. This test sequence used an upwind, rigid turbine with a 0° cone angle. The wind speeds ranged from 5 m/s to 15 m/s, and data were collected at a 0° yaw angle. The rotor rotated at 72 RPM. Blade and probe pressure measurements were collected. The teeter dampers were replaced with rigid links, and these two channels were flagged as not applicable by setting the measured values in the data file to -99999.99 Nm. The teeter link load cell was pretensioned to 40,000 N. The blade pitch angle was changed from the initial tip pitch angle to the final tip pitch angle at the maximum rate of 67°/s. This angle was maintained for the specified delay time duration. Then the blade was pitched back to the initial pitch angle and held for the specified hold time. This was repeated 20 times. The campaign at 15 m/s was aborted early due to excessive low-speed shaft torque loads. The file length varied depending on the time required to obtain 20 pitch cycles for the specified range of angles. The name convention was the standard format, except for the short campaigns collected to ascertain the functionality of the instrumentation. These points were collected at a 3° pitch angle and use the characters REF in the four digits that normally represent yaw angle.

Read more ...


Data access is enabled only after registering with A2e.

Data and Resources

Additional Info

Field Value
Source https://a2e.energy.gov/data/uae6/uae6.z16.00
Author Ken Burk
Maintainer Atmosphere to Electrons (A2e)
bureau_code 019:20
Catalog EERE
harvest_object_id 6295b068-1d68-4276-a4e2-887f68fdca15
harvest_source_id f795d0bf-de6a-4a81-a253-24cf9ef38e1d
harvest_source_title DOE Opendata
was_harvested true

Package Relationships

Relationship Dataset